Jonno 0 Posted February 20, 2013 I have finally managed to remove the centre nut on my clutch but can't seem to get the thing off! Any suggestions??? Share this post Link to post Share on other sites
Topcat 58 Posted February 20, 2013 Use a couple of bits of wood and gently tap/lever the basket off by sliding them down the back. Give the basket a good dose of WD 40 first,bike on it's side spraying on the inside round all the centre slots of the shaft. Share this post Link to post Share on other sites
Jonno 0 Posted February 20, 2013 Thanks topcat that sounds like a plan. I am taking it off to replace the basket bearing. Any ideas what's the best way to get the old bearing out or do you need a press/puller? Cheers Share this post Link to post Share on other sites
paul90210 40 Posted February 20, 2013 take the circlip out and tap the bearing till it comes out. when putting the new one in try heating the basket up slightly, that should help to get it in easier. Share this post Link to post Share on other sites
