Stevo2000 1 Posted September 30, 2022 (edited) Hi,I bought a 2nd hand rotor which was still in the engine casing and I can't seem to budge the retaining nut. Any tips, trick or remedies for sorting? I take it it's standard Threaded? Edited September 30, 2022 by Stevo2000 Share this post Link to post Share on other sites
Ray Stadia 1,071 Posted October 6, 2022 On 9/30/2022 at 10:38 PM, Stevo2000 said: Hi,I bought a 2nd hand rotor which was still in the engine casing and I can't seem to budge the retaining nut. Any tips, trick or remedies for sorting? I take it it's standard Threaded? Can you put up a photo? If you mean the half time pinion, I believe it's a right handed thread (in other words, the other way). Also, you may need a specific puller to get it off the taper. I had to for an 897. Share this post Link to post Share on other sites
Stevo2000 1 Posted October 8, 2022 Thanks Ray. absolutely correct about the reversed thread managed to manufacture a puller so I've got that off now. I just need to try and get the original PAL one off now to replace that which is proving just as difficult as the thread inside is chewed up 1 Share this post Link to post Share on other sites
